While designing a building or a house, you choose the construction material depending on the type of project you are working on. Whether you are building a residential home or a commercial building you will decide the panel and post retaining walls according to the project requirements. Depending on the application and the type of feel you want to go for you will need to decide what type of wall will work best for the site. If you pay attention only to the design and appeal aspect of the wall then the whole purpose of the wall will fail.
Building a retaining wall requires understanding of various environmental factors as well as careful planning and layout. In this article, you will learn about some of the crucial factors that you need to consider in the initial design phase of your wall to avoid any kind of hazard.
- Location: When you choose a location for your wall, make sure that you understand both above the ground as well as under the ground utilities. You should also have knowledge about the property lines and the management system as well as the irrigation procedure. Make sure that you judge the land type as well. Consider factors like storage of infills if you are constructing a wall on the slopes. If you are constructing on a hillside, make proper arrangements to store the soil. Study the drainage patterns. If the wall is constructed for security of a property, is it encroaching the neighbour’s property line? Considering these initial points will make the process simpler.
- Soil: Before starting any construction, it is best to study the type of soil that is going to be the foundation of the construction. You should also determine the bearing capacity of the soil. If the construction is too heavy, the soil might slip off underneath and it might be hazardous. Simply speaking, the basic nature of the soil should be non-slippery, firm and non-moist. Any type of clay or wet soil is a big no! Also if you are building a wall where the area is freezing, the soil could be prone to cracking. Thus the best option is grainy sandy surfaces where good drainage is easily possible.
- Design: The height, width and the texture of the wall are the main components that determine its design. you need to begin by calculating the corresponding wall heights and the angle of elevation of the wall. Consider the gravity which is responsible for retaining the wall, especially when you are constructing on slopes. Your design should be in favour of lateral earth pressure behind the wall. If the gravity isn’t your favour then there are various other artificial reinforcement ways to assure stability of the wall. Calculating the gravity will help you to decide the best method for setting up the wall.
- Drainage: Improper drainage is the most common reason why retaining walls fail. This is why it is important to ensure that adequate water reaches the wall. Make sure that there shouldn’t be any build up of water behind the walls. Assuring proper drainage is easy. you just need to indentify a source of water and drainage adjacent to the wall.m this can be done using drain pipes , weep holes or gravels. Anything that allows the water to pass through the wall would suffice.
Building the right type of wall for a property should be done with the help of reliable professionals. Whether you want to build a limestone wall in Perthor concrete wall, it is important that you give the project to a well experienced contractor like Stronglock.com.au.